Equipped with revised universal brackets for an easy installation process.

The 4 copper heat pipes are updated with an Asymmetrical tilt for a 100 RAM clearance. All of them are half way or maybe 3/4 through, to me it seems tight enough, certainly the heatsing is not moving/sliding about and I know from DIY stuff that's it's never good to overtighten the any screw (especially when hooked to a new motherboard/cpu). Hyper 212 EVO V2 & SickleFlow 120 V2 RGB Bundle combines the redesigned Air Cooler and Fan to improve overall performance, compatibility, and installation. I started tightening and after a while one of the screws couldn't tighten further easily, so I tighten the rest 2-3 turns and then stopped. I removed the whole thing, cleaned again, reapplied thermal paste and tried it the other way round, after some messing about I could get all 4 of them in but it was difficult. I thought to myself this can't be right, it shouldn't be this difficult. I could get 3 of the screws in, but the fourth one just couldn't alighn, after a lot of time I managed to push it in but it wasn't straight. I install with the cooler facing the rear, normally it should be facing the top on an AMD system. Find low everyday prices and buy online for delivery or in-store. Hmm, I had a VERY VERY hard time getting all four spring screws to adjust and tighten properly on my AMD board. Shop Cooler Master Hyper 212 RGB Black Edition 120mm CPU Cooling Fan Jet Black at Best Buy.

Cooler master hyper 212 evo install